The following settings must be made to transport the
OptiFlex-K1:
Set the packing setting in the menu or move the device
in a position of EXTENSION 0 degrees.
Switch off the OptiFlex-K1.
Remove the power cord and disconnect the hand
held programming unit.
Only use original packaging for transport.
Put the hand-held programming unit into the extra box.
Set the femur lenght on maximum and the lower leg
setting on 42 cm.
Set the angle joint horizontal.
5
Move the two styrofoam parts and the extra
protection for the knee joint on the device
First put the power cord and the extra box with the hand
held programming unit on the bottom of the box as shown
on the figure below and then the OptiFlex-K1 with the two
styrofoam parts.
4. Packing and unpacking the OptiFlex-K1
Extra box with the hand-held
programming unit
Extra protection for
the knee joint
