MODULAR SERVICE TOOL SD
12
VCB-X Operator Interface SD
Setting the Operating Mode
The Operating Mode is displayed on the last line of the
Main Screen
as shown below. The factory default setting for the Service Tool is
LS
(Low Speed) Stand Alone Mode
.
LS Stand Alone Mode
is the correct
con
fi
guration for the VCB-X Controller when in Stand Alone Mode.
Service Tool SD vX.XX
01/16/15 02:21 PM
LS Stand Alone
No Communication
If you are using this Service Tool on a communications loop and have
an installed MiniLink PD or CommLink, you will need to change the
setting to
LS (Low Speed) Network Mode
.
If you are using a VCB-X Controller that is set for high speed, you will
need to change the setting to
HS (High Speed) Stand Alone Mode
or
HS (High Speed) Network Mode
.
If your display indicates a different mode than the one you need,
press
<2>
at the
Setup Screen
shown below. You may have to
press
<NEXT>
to access this screen.
1) Set Time & Date
2) Communications
NEXT) More Options
ESC) Exit Menu
The
Communications Screen
will appear as shown below.
Stand Alone Mode
Lo Speed Connection
Use Left/Right Arrow
To Change Selections
Press
<
>
or
<
>
to select the proper mode of operation.
When you have made your selection,
press
<ENTER>
.
The following
screen will appear.
You Have Changed The
System Mode
Press Any Key To
Continue
Press
any key to continue. The
Setup Screen
will appear as shown below:
1) Set Time & Date
2) Communications
NEXT) More Options
ESC) Exit Menu
Setting the Operating Mode and Energy Saving Timer
Setting the Energy Saving Timer
The Modular Service Tool has a built-in timer that can be programmed
to shut the Service Tool off after a speci
fi
ed period of time if no buttons
are pressed. This is a very useful feature if you are powering the Service
Tool from the internal batteries.
To set the Energy Saving Timer,
press
<NEXT>
at the
fi
rst
Setup Screen
and
<3>
at the second
Setup Screen
shown below. (You may have to
press
<NEXT>
to access these screens).
1) Set Time & Date
2) Communications
NEXT) More Options
ESC) Exit Menu
3) Energy Saving
4) Update Software
NEXT) More Options
ESC) Exit Menu
The
Energy Saving Screen
will appear as shown below:
Energy Saving
Automatic Power Down
Minutes: xx
Press ESC to Exit
Enter the number of minutes you want the Service Tool to stay active
before it automatically powers down and
press
<ENTER>
. To cancel
the automatic power down,
enter
<99>
and
press
<ENTER>
. After
you have entered a number between 1 and 99 minutes,
press
<ESC>
to exit the screen.
The
Setup Screen
will appear again as shown below:
1) Set Time & Date
2) Communications
NEXT) More Options
ESC) Exit Menu
