27
AT THIS POINT ON THE GRAPHIC DISPLAY THE INITIAL SCREEN WILL APPEAR THAT WILL INVITE
TO THE MACHINE SWITCHING ON WITH THE INDICATION “PRESS START “. AT THIS POINT PRESS
“START” ON THE DISPLAY.
Picture 15: Orion LZR touch screen interface
When you have pressed “START” on the display the default set values will appear and the inscription
“VERIFICATION VALUES LASER ACTIVE” (Fig. 6)
NOTE
Do not proceed with the installation if the display does not show as described
above. If you encounter any problems or errors, consult chapter 8 of this docu-
ment, or contact Sunstone Engineering.
At this point the operator will be able to:
•
Select the welding parameters and begin welding.
•
Load a previously saved setting and begin welding.
5.3: WELDER SWITCHING OFF
ATTENTION:
Before flipping the power switch, make sure to always turn the key to the locked
position. This will allow the microprocessor to drain the internal capacitors.
Содержание LZR series
Страница 1: ...Orion Laser Welder User Manual Orion LZR ...
Страница 4: ...4 ...