■ When not in use, the Nailer, fuel cell and battery
should be stored in a warm and dry place.
■ Keep it out of reach of children.
4
. WARNING LABEL
Change the WARNING LABEL if missing or
damaged.
A new WARNING LABEL is available
from a
ORION
authorized service center.
5
. Maintenance chart
ACTION
WHY
HOW
Clean magazine and Prevent a jam.
Daily cleaning.
feeder mechanism.
Keep push lever
Promote operator Daily cleaning.
working properly. safety and efficient
Nailer operation.
Make sure all screw Avoid the nailer been
Periodical
are tightening.
damaged, make
inspection.
sure the safety.
6
. Operator troubleshooting
See page 18.
CAUTION
Repair, modification and inspection of
ORION
Power Tools must be carried out together with
the
replacement parts list by an
ORION
Authorized
Service Center.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
MODIFICATIONS:
ORION
Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.
SERVICE AND REPAIRS
WARNING
■
Only service personnel trained by
ORION
,
distributor or employer shall repair the Nailer.
■
Use only parts supplied or recommended by
ORION
for repair.
All quality Nailers will eventually require servicing
or replacement of parts because of wear from normal
use.
NOTE
Specifications are subject to change without any
obligation on the part of
ORION
.
Cleaning interval
Operation Environment
Nials Driven/week Very dirty Dirty Moderate Clean
5000
1 Week 3 Week 1Month 2Month
7500
1 Week
2 Week
3 Week
1Month
10000
3 Days
1 Week
3 Week
1Month
Note
After completion of each cleaning must drip
the lubricating oil (504.6.03.001.01) to the
nailer the place which shown in attachment
Gas Finish Nailer Cleaning Guide .
If you have any questions about of the cleaning
operating procedures and methods, please contact
with
ORION
authorized service center.
2
. Inspecting the magazine
①
REMOVE FUEL CELL and BATTERY.
②
Clean the magazine.
Remove paper chips or wooden chips which
may have accumulated in the magazine.
③
Lubricate it with
ORION
designated lubricant oil.
CAUTION
Check that the nail feeder slides smoothly by
pulling it with finger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
3. Storing
DANGER
■
Store Nailer properly with nails,
fuel cell and battery removed .
■
The fuel cell is an aerosol dispensers
with flammable contents.
■
When not in use, the Nailer, fuel cell and battery
should be stored in tool case and in a dry place
and below temperature 122°F (50°C).
■
Store indoors at temperature 41°F (5°C)
～
77°F
（
25°C
）
.
■ When not in use for an extended period, apply a
thin coat of the lubricant to the steel parts to avoid
rust.
■ Do not store the Nailer
、
fuel cell and battery in
a cold weather environment.
20
Cloth
