8
4. Accessories
DANGER
Accessories other than those shown below can lead
to malfunction and resulting injuries.
STANDARD ACCESSORIES
1.Safety Glasses·················································
2.Allen Wrench for M5 Screw ····························
3.Lubricant Oil····················································
4.Nose Cap(mounted on tool)····························
5.Battery ····························································
6.Charger ···························································
7.Adapter····························································
8.Box ·······························································
OPTIONAL ACCESSORIES
sold separately
1.Fuel Cell
2.Cleaner
(Code No. 504.6.04.001.01)
REMOVAL AND INSTALLATION METHOD OF
BATTERY
1. How to install the battery
Align the battery with the groove in tool handle
and slip it into place. Always insert it all the way
until it locks in place with a little click. If not, it
may accidentally fall out of the tool, causing
injury to you or someone around you.
2. How to remove the battery
Withdraw battery from the tool handle while
pressing the button on the back of the battery.
CHARGING METHOD
NOTE
: Before plugging into the receptacle, make
sure the following points.
■
The power source voltage is stated on the nameplate.
■
The cord is not damaged.
WARNING
■
Do not charge at voltage higher
than indicated on the nameplat e.
If charged at voltage higher than
indicated on the nameplate, the
charger will burn up.
■
Do not use the electrical cord if damaged.
Have it repaired immediately.
■
ORION
charger(504.4.04.010.XX) only use for
ORION
battery (504.4.04.011.08), and
ORION
battery(
504.4.04.011.08
) also only use for
ORION
charger(
504.4.04.010.XX
), if not, may
cause the charger damage or battery burst.
STEP:
1. Insert the battery into the charger base. Make
sure it contacts the bottom of the charger base .
2. Insert the connection plug of adapter into the
receptacle of the charge base.
3. Insert the power plug of the adapter into the
plug seat.
4. Charging
■
When the plug of charger adapter has been inserted
into the plug seat , charging will commence and the
green pilot lamp will light flash.
■
Approx. 200 min. at 70°F (20°C), when the
battery is fully charged, the green pilot lamp
light on.
■
Red flash & green light off,charging problem.
1
2
3
5
6
7
8
Handle
Latch
insert
pull out
1
2
1
2
1
1
1
4
1
