4
EN
REMOTE SENSOR (THN122N)
SETUP SENSOR
This product is shipped with a THN122N Thermometer
Sensor that collects Temperature data. Data can be
collected from up to 3 sensors. Additional sensors sold
separately.
1. Open the remote sensor battery compartment with
a small Phillips screwdriver.
2. Insert the batteries, matching the polarity (+ and -)
as shown in the battery compartment.
3. Set the channel. The switch is located in the battery
compartment.
4. Place the sensor near the main unit. Press
RESET
on the sensor. Then, press and hold
MEMORY
and
CHANNEL
on the main unit to initiate signal
sending between the sensor and the main unit. The
reception icon on the main unit will blink for
approximately 3 minutes while it is searching for the
sensor. (Refer to the “Data Transmission” section
for more information.)
5. Close the remote sensor battery compartment.
6. Secure the sensor in the desired location using the
wall mount or table stand.
UNIT
LOCATION
Main
Indoor Temperature Area
Remote
Outdoor Temperature Area
GETTING STARTED
BATTERIES
Batteries are supplied with this product:
Main unit
3 x UM-3 (AA) 1.5V batteries
Remote unit
2 x UM-4 (AAA) 1.5V batteries
Insert batteries before first use, matching the polarity (+
and -) as shown in the battery compartment. For best
results, install batteries in the remote sensor before the
main unit. Press
RESET
after each battery change.
NOTE
Do not use rechargeable batteries.
shows when batteries are low.
NOTE
It is recommended that you use alkaline
batteries with this product for longer performance.
Installing the batteries:
CHANGE SETTINGS
To change, time, calendar and language settings:
1. Press and hold
MODE
for 2 seconds to enter
setting mode.
2. Press
or
to change settings. (To reach the
setting you want quickly, press and hold
or .)
3. Press
MODE
to confirm.
SWITCH
OPTION
Channel
Channel 1-3. If you are using more than
one sensor, select a different channel
for each sensor.
BAR636_M_EN.p65
2005.4.28, 9:44 AM
4
