20
• If there is no blockage in the hose.
Remove the power
nozzle from wand and attach wand to hose. Check for
suction and remove any blockages.
Nozzle Blockage
•
If the nozzle becomes clogged, use the following
procedures to check for and clear the blockage.
•
If blockage is severe enough the nozzle will shut
off. After the blockage is cleared you must push the
Overload Protection Reset
button (A) before the
nozzle will operate again.
•
Make sure power nozzle is disconnected from wand.
Then check for blockage in nozzle connection (B).
•
There is an additional panel on the bottom of the
nozzle (C). This opening provides a secondary place
to check and clear blockage.
Maintenance
- continued
