Orbis VIARIS COMBI, Инструкция по эксплуатации, Страница: 70 / 120

22
Charger connected to the vehicle and
time schedule but not load
If the time scheduling indicator is on
(
), pass the RFID card to activate the
time schedule.
If the time scheduling indicator is off, the
vehicle does not support external time
programming. Schedule the time interval
on the vehicle itself, and delete the loader
schedule.
The protections of the installation are
triggered
If the charge modulation indicator is off,
the TMC100 is not properly connected.
Check connection to the terminals,
direction of current and that the TMC100
is well closed, as indicated in the Load
Modulator section.
If the charge modulation indicator is
on, the adjusted power does not
match the contract.
After manual deactivation or with RFID
card the load does not stop and the
intake is blocked
Release and disconnect the vehicle hose.
If it has been activated with an RFID card,
check that it is the same one that was
used in the activation or that it is
authorised. If the problem persists,
release and disconnect the vehicle hose.
The charger could not connect to a
WiFi network
If the WiFi indicator is off and does
not go to fixed target, it is because the
charger has not been correctly configured
or the correct password has not been
entered.
If the WiFi indicator is blinking blank, it’s
because it’s connected to an unconnected
WiFi network or the network security is
blocking it.
After the loading process, the charger
remains connected to the vehicle with
the locked pin, fixed green status bar
Reset: Rearm the protections and restart
the charger to remove the pin.
Exceeding maximum power The modulator hasn't worked.
Check the configuration according to the
power contracted.