30
EN
Water drainage
1 Manually Discharged (See Figure 12)
1
When the unit turns off when water is full, turn off the power and disconnect
the unit from the mains.
Note:
Carefully move the unit to prevent water from spilling into the water tank on
the bottom of the unit.
2
Place a suitable water container below the water outlet (drain plug) on the
back of the unit.
3
Unscrew the drain plug and pull off the plug.The water begins to run into
the underlying vessel
Note:
1. Remove drain plug and plug.
2. Slightly tilt the unit slightly when draining.
3. If the water tank is insufficient for its drainage capacity, discontinue the
drain by pushing the plug and replace the container to prevent water from
leaking to the ground or to the carpet.
4
After fully draining the water, firmly insert the plug and screw in the water cap.
Note:
Turn the unit back on after properly fitting the plug and the cap. Otherwise,
the condensate can escape from the unit to the ground or to the carpet.
fig. 12
plug
drain
seal
drain
