29 |
P a g e
7.4.2 EZ DRUMMER LITE/TOONTRACK SOLO
EZ Drummer comes pre-installed on your OPC as a VST plug-in and as part of the Toontrack Solo
standalone application. To change the Device Driver from within Toontrack Solo: select Options >
Audio> Audio Device. By default Device Type should be set to ‘ASIO’ and the Output Driver to ‘ASIO
2.0 - OPC’ as shown in the example below.
7.4.3 MIXCRAFT
After opening Mixcraft and you’re in a project: select File > Preferences. Here you’re able to select
between driver modes. By default the Driver should be ASIO and the Default Recording Device
should be ‘OPC 1/2:L OPC1/2:R’. The Playback Device should be set to the same device.
Note that when using the ASIO you’re limited to only using the top panel guitar/mic jacks and the
rear 1/4” ports. This is the nature of the low latency ASIO technology used. If you plug in a USB
device for recording, you’ll need to switch over to the WaveRT driver or use that devices ASIO driver
if available.
