Manual for Tire Pressure Monitoring Systems, TPMS
5/17
Sensor Relearn Method
When you first install the receiver and display unit, you will need to do the relearn process
the learn TPMS signal. After the relearn process, the receiver and display will record the
sensor’s ID inside. When tire rotation, please do the relearn process again to make sure
sensor ID is properly recorded.
The receiver and display receive wireless signal from sensors. The receiver and display could
reset through the below process to ensure the tire position and tire pressure is correctly
corresponded.
There are two methods for relearn process:
Mode 1:
Four Tire ID Learn
When you are replacing 4 sensors or your tire pressure position is in disorder, use
this relearn method. Following the relearn process in the order of FR (front right) -
RR (rear right) - RL (rear left) - FL (front left).
Mode 2:
Single Tire ID Learn
When you are replacing only one sensor, you could this method to do the ID relearn.
Warning
1. Do not turn off the vehicles power during this process. Doing so will immediately
interrupt the repositioning setup process. The ignition can either be in the on or start
position.
2.
After repositioning, check the display is detecting all tire pressures correctly. If the
system cannot work normally, please reset it and follow the instructions again (At this
time, enter Mode 2 to use single sensor replaced).
No.1 → Front Right Tire
No.2 → Rear Right Tire
No.3 → Rear Left Tire
No.4 → Front Left Tire
No.1
No.2
No.4
No.3
