Oracle X7-2, Руководство по установке

Страница: 88 / 148

Exit Oracle ILOM
Exit Oracle ILOM
See the following procedure to log out of the Oracle ILOM web interface or CLI.
To end an Oracle ILOM session:
■ Oracle ILOM web interface – Click the
Log Out
button in the top-right corner
of the screen.
■ From the Oracle ILOM CLI – Type
exit
at the CLI prompt.
Modifying Network Settings
This section provides information about the default network settings on the service processor
(SP), and procedures for viewing and modifying those settings in Oracle ILOM:
■
“Modifying Network Settings” on page 88
■
“Test the IPv4 or IPv6 Network Configuration” on page 90
The servers support dual-stack IPv4 and IPv6 settings, which enable Oracle ILOM to fully
operate in an IPv4 or IPv6 network environment.
■
IPv4 configurations – DHCP is enabled by default, allowing a DCHP server on the
network to automatically assign network settings to the service processor.
■
IPv6 configurations – IPv6 stateless auto-configuration is enabled by default, allowing an
IPv6 router on the network to assign the network settings.
In a typical configuration, accept the default settings. However, if you want to modify the
service processor network settings, use the following procedures.
Modify Network Settings
When you use Oracle ILOM to deploy or manage the server, you can optionally modify the
default network settings provided for the service processor (SP).
This procedure provides web interface and CLI instructions for viewing and modifying the
network settings that are assigned to the SP.
88 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017