Oracle T5140, Руководство по установке

Страница: 62 / 115

Powering On the System 51
In this procedure, you connect to the ILOM service processor using the serial
management port to manually reconfigure the network management port.
Note –
For more information on configuring ILOM, refer to the Integrated Lights Out
Manager Supplement for Sun SPARC Enterprise T5140 and T5240 Servers .
Set these network parameters according to the specific details of your network
configuration:
■ /SP/network state
– Specifies whether the service processor is on the network
or not
■
/SP/network pendingipaddress
– IP address of the service processor
■ /SP/network pendingipgateway
– IP address of the gateway for the subnet
■ /SP/network pendingipnetmask
– Netmask for the service processor subnet
■
/SP/network pendingipdiscovery
- Specifies whether the service processor
uses DHCP or static IP address assignment
■
/SP/network commitpending
- Commits the service processor to use the
pending settings
Configure these parameters with the
set
command. The usage is as follows:
set
target property = value where
/SP/network
is the target and
pendingipaddress
= xxx.xxx.xxx.xxx , for example, is the property = value .
1. Configure the service processor using information from your network
administrator.
Your choices are:
■ dhcp
- Set up the network connection with a dynamically created IP
configuration.
■
static
- Set up the network connection with a static IP configuration.
a. If you choose to use a dynamically created IP address (use DHCP to retrieve
the network setting), set
pendingipdiscovery
to
dhcp
.
b. If you choose to configure a static IP configuration, set the parameters
pendingipdiscovery
,
pendingipaddress
,
pendingipgateway
, and
pendingipnetmask
as follows.
i. Set the service processor to accept a static IP address.
-> set /SP/network pendingipdiscovery=dhcp
Set 'pendingipdiscovery' to 'dhcp'
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'