Oracle Sun ZFS, Руководство по обслуживанию

Страница: 72 / 146

13. Connect the power cords to the power supplies.
14. Verify that standby power is on, indicated by the Power/OK status indicator flashing on the
front panel about two minutes after the power cords are plugged in.
15. Use a pen or other pointed object to press and release the recessed Power button on the
storage controller front panel. The Power/OK status indicator next to the Power button
lights and remains lit.
16. Connect data cables to the PCIe card, routing them through the cable management arm.
17. Go to the Maintenance > Hardware screen of the BUI, and click the details icon on the
controller. Then, click Slots to verify the status of the new component. The status indicator
should appear green .
18. Install the disk shelf and connect the expansion storage.
Battery
You might need to replace the battery if the storage controller fails to maintain the proper time
when powered off and disconnected from the network. You will need a small (No.1 flat-blade)
non-metallic screwdriver or equivalent.
You
must
shut down the appliance before beginning this task. Note that there will be a loss of
access to the storage unless the system is in a clustered configuration. Shut down the appliance
using one of the following methods:
■
Login to the BUI and click the power icon on the left side of the masthead.
■
SSH into the storage system and issue the
maintenance system poweroff
command.
■
SSH or serial console into the service processor and issue the
stop /SYS
command.
■
Use a pen or non-conducting pointed object to press and release the Power button on the
front panel.
■
To initiate emergency shutdown, wherein all applications and files will be closed abruptly
without saving, press and hold the power button for at least four seconds until the
Power/OK status indicator on the front panel flashes, indicating that the storage controller
is in standby power mode.
1. Disconnect the AC power cords from the rear panel of the storage controller.
2. Verify that no cables will be damaged or will interfere when the storage controller is
extended from the rack.
3. From the front of the storage controller, release the two slide release latches.
4. While squeezing the slide release latches, slowly pull the storage controller forward until the
slide rails latch.
5.
7120 or 7320:
To remove the top cover:
Unlatch the fan module door, pull the two release tabs back, rotate the fan door to the open
position and hold it there.
7x20
Sun ZFS Storage 7x20 Appliance Customer Service Manual • December 2011 E26399–02 72