Oracle Fabric Interconnect F1-15, Руководство пользователя

Страница: 87 / 176

Connect to a Fabric Interconnect F1-4's Management Module
FIGURE 55
Fabric Interconnect F1-15 Management Module for Connection to Management
Console
There are two ways to connect to the serial port on the Fabric Interconnect Management
module:
■
Connect directly to the Serial 1 port on the Management module. This
step requires an adaptor that supports straight-through CAT-5 cable (or
the equivalent). See “Connecting the Management Port to a DB9 Serial
Port” on page 86 .
■
Connect a remote system to the Serial 1 port using a serial console terminal
concentrator (for example, Cyclades).
2.
Verify that the serial port on your system is set up as follows:
■ 115200 baud
■
8 bits, no parity
■
VT100 encoding
■
1 stop bit
Note - The Serial 2 port is used for debug purposes only.
Connect to a Fabric Interconnect F1-4's Management Module
The procedure in this section documents using a serial connection to the Fabric Interconnect's
management port. However, a default address is set for the Management port (192.168.1.1), so
you can also use an Ethernet connection for initial configuration of the Fabric Interconnect.
To connect to the Management Module on a Fabric Interconnect F1-4:
1. Connect a laptop or a remote console to the Serial 1 port on the Management
module. (This connection is required for the initial system configuration.) See
Installing the Fabric Interconnect 87