Oracle e-series, Руководство по установке

Страница: 55 / 82

Installing and Operating the Tablet and Base Station E-Series 3-19
Installing the Tablet E-Series 11 wakes up the Base Station E-Series through the multi-
function docking connector. The Base Station Power LED turns Green to indicate that the
Base Station is on.
When docked on the Base Station, the Tablet E-Series 11 Power Button controls both
devices.
Removing the Tablet E-Series 11 causes the Base Station E-Series to shut down within 30
seconds unless the optional Base Station E-Series battery is charging. In this case, the
Power LED turns off, but the Battery LED remains on to indicate the charge level. When
the battery is fully charged, the Battery LED turns off.
Installing the Optional Base Station E-Series Smart Battery
The optional Base Station smart battery is an 11.1V, 7200mAH Li-Ion battery pack, Totex
DR202I. The pack consists of nine rechargeable 18650 form factor Li-Ion cells arranged in
a 3S3P (3-Serial, 3-Parallel) configuration.
The battery pack complies with the Smart Battery Data Specification SBS 1.1
communicating with the Base Station MCU over the System Management Bus (SMBus).
It can be used in both the Base Station E-Series and Base Station R-Series.
1.
Remove the thumbscrew that holds the battery compartment cover.
2. Install the battery as shown in the figure below.
Figure 3-17 Installing the optional Base Station Battery Pack
3. Reinstall the battery compartment cover.
4. (Optional) Install a 2mm hex head screw as shown to secure the battery compartment
cover.
Figure 3-18 Securing the Battery Compartment Door and Battery Check