Oracle Acme Packet 6100, Руководство по установке оборудования

Страница: 43 / 114

Acme Packet 6100 Hardware Installation Guide 35
Mounting System
Acme Packet provides flexible mounting options for your Acme Packet 6100
equipment rack installation.
The mounting system consists of a slide rail mounted on each side of an
equipment rack and a chassis slide rail mounted on each side of the Acme
Packet 6100 chassis. Once the slide rails are installed on the equipment rack
and chassis, the chassis can be slid into place by aligning the installed chassis
slide rails along the guides on the equipment rack slide rails. When the Acme
Packet 6100 is fully inserted into the equipment rack, it is secured in place with
two captive thumbscrews.
Installing the
Equipment Rack
Slide Rails
In the first stage of system installation, secure the equipment rack slide rail to
the equipment rack. The painted end of the equipment rack slide rail attaches
to the front of the equipment rack and the bare steel side attaches to the rear
of the equipment rack. The equipment rack slide rail can expand and contract
to accommodate equipment racks of various depths up to 32”.
You can mount the equipment rack slide rail to both tapped hole rack rails and
square rack rails. Follow the appropriate procedure below.
Installing Slide Rails
into a Tapped-Hole
Rack This section explains how to mount the Acme Packet 6100 slide rail assembly
into a tapped hole equipment rack.
Note: The following procedure presumes that the tapped hole size
is #10-32. If alternate tapped holes are used, the customer must
supply the proper screws.
To install the slide rails to the front of a tapped-hole equipment rack:
1. Locate the following components:
• Assembled equipment rack slide rails (2)
• #10-32 x 5/8” screws (8)
• Mounting spacers (2)
2. Line up the painted side of the equipment rack slide rail with an
appropriate mount point on the front of the equipment rack.

Figure 4 - 43. Aligning the Slide Rail Front Mount Point in a Tapped-Hole Rack