1
Before operating the machine please read the safety precautions, manufacturer
recommendations and the operation manual. The operation manual should be easily
available at any time for the operator.
•
The machine should be installed on sturdy and level floor near the
AC 220 – 240 V 50/60 Hz socket.
•
The machine should be protected against dust and moisture.
•
The machine must not be placed near the heating units or ventilation units.
•
The machine should not be used in vicinity of inflammable liquids or gases.
•
Any heavy or sharp objects should not be put on the machine.
•
The supplying cable should be protected against any damage, must not be used
to pull the machine or to remove the plug from a socket. If the cable is damaged
it must be exchanged immediately.
•
During a long standstill or before replacing the machine, the plug should be
removed from a mains socket.
•
The machine should be kept away from children’s reach
•
Danger! Machine contains rotary elements. Take care of long hair, loose jewellery,
ties and other loose pieces of clothing – they can be entangled into the rolls.
•
Danger!! The machine contains heating area – pay special attention. Do not touch
the machine or put any inflammable materials on the machine!
•
After using the laminator must be turned off by main switch or by unplugging it
from the power socket. Do not cover the feed opening, so that the rolls cool down.
•
The machine must not be used for any other purposes than those indicated in the
instruction manual.
•
It is necessary to check and supervise if the machine operates correctly. In case of
any malfunctions, it is required to contact the service team
•
The machine must not be located outside, should be operated in room
temperature higher than +8C.
•
Before removing any cover from the machine, remove the plug from a socket.
•
Using inappropriate lubricants causes the fire hazard
•
The machine should be operated according to general safety rules.
•
The machine should be unplugged immediately, in case of any defect. Any repairs
can be conducted only by authorised staff.
•
There are high voltage parts inside this machine. To avoid electric shock,
do not open the cover without authorized service man
•
Be careful when using end cutter and side cutter.
•
Do not touch the rollers while operating or directly after operating to avoid any
possible scald.
•
Moving parts can crush and cut.
•
Surface is hot. A burn hazard exist.
SAFETY PRECAUTIONS
8
