3 DISPLAY PCB
HOT
- Temperature of roller keeps 110
0
C, Speed Step 3.
STBY
- Temperature of roller keeps 8
0
C
MEAS
- Height that see present temperature of roller
COLD
- Use when cool temperature of roller.
TEMPERATURE (UP&DOWN)
– temperature regulation
MEMO (M1, M2, M3)
- It is usable function simply input temperature and speed that
use often.
MEMORY1
: 130
0
SPEED 3.
MEMORY2
: 140
0
SPEED 3.
MEMORY3
: 150
0
SPEED 3.
SPEED (UP&DOWN)
– Speed regulation
ºC / ~F
– change of scale
REV
- When reverse by function that reverse roller, revolutions per minute is speed on step.
RUN/STOP
– run or stop
OPUS RolLAM 720 • User guide
GB
9
2 RECOMMENDATIONS
•
Use only recommended supplies and accessories.
•
The machine is designed for lamination with pouch 25 – 250μm. Do not use different
pouch thickness.
•
Always insert the pouch with the close end into the laminator. Putting the open end first
can cause stuck of the document inside the laminator.
•
Laminating with the one layer of pouch requires using the carrier.
•
Individually cut pouch can badly dirt the rolls or wind around them.
•
Remove all metal elements (clips, clamps, etc.) before laminating the document.
•
Do not laminate inflammable, sticky and easy-melting materials
NOTE! Not complying with the recommendations above can result with warranty void.
4 MEMORY INPUT METHOD
•
Twinkle MEMORY two periodically if press memory key during about 5 seconds.
•
This time, if wish to exchange soil rake of memory, press memory key shortly once.
•
Into memory soil rake that select temperature and speed value if press MEAS key after
selection long wealth low tone and input complete.
•
Press method and any key except TEMP, SPEED.
Laminator will not work properly when its pushed more than two keys at the same time.
