5 HOT LAMINATION
10
Instrukcja obsługi
/ User guide OPUS rolLAM 720
9
Display PCB
HOT -
Temperature of roller keeps 110
℃
, Speed Step 3.
STBY -
Temperature of roller keeps 80C
MEAS -
Height that see present temperature of roller
COLD
- Use when cool temperature of roller.
TEMPERATURE
(UP&DOWN)
–
temperature regulation
MEMO
(M1, M2, M3) - It is usable function simply input temperature and
speed that use often.
MEMORY1 : 130
℃
SPEED 3.
MEMORY2 : 140
℃
SPEED 3.
MEMORY3 : 150
℃
SPEED 3.
SPEED
(UP&DOWN
–
Speed regulation
ºC / ~F
–
change of scale
REV
- When reverse by function that reverse roller,
revolutions per minute is speed on step.
RUN/STOP
–
run or stop
Memory input method
Twinkle MEMORY two periodically if press memory key during about 5 seconds
This time, if wish to exchange soil rake of memory, press memory key shortly once
Into memory soil rake that select temperature and speed value if press MEAS key after
selection long wealth low tone and input complete
Press method and any key except TEMP, SPEED
Laminator will not work properly when its pushed more than two keys at the same time
HOT Laminating
Release paper
Safety cover
Object
Feed tray
Temperature sensor
Release paper
After finished work be careful of hot parts of laminator. A burn hazard exist.
If the temperature of roller measures over 60˚C, must not
operate COLD LAMINATING. Wait
until cools down
Make sure nothing around infrared temperature sensor that hide sensor.
•
After finished work be careful of hot parts of laminator. A burn hazard exist.
•
If the temperature of roller measures over 60˚C, must not operate COLD LAMINATING.
Wait until cools down.
•
Make sure nothing around infrared temperature sensor that hide sensor.
POUCH
OBJECT
SETTINGS
TEMPERATURE
SPEED
Under 50 μm
50 μm 100 μm
100 μm 150 μm
150 μm 250 μm
below 100 g 720 mm width
115
115
120
125
3.0 m/min
2.7 m/min
2.2 m/min
1.1 m/min
Under 50 μm
50 μm 100 μm
100 μm 150 μm
150 μm 250 μm
100 g ~ 150 g 720 mm width
115
115
120
125
2.7 m/min
2.2 m/min
1.6 m/min
1.1 m/min
Under 50 μm
50 μm 100 μm
100 μm 150 μm
150 μm 250 μm
150 g ~ 300 g 720 mm width
115
115
120
125
2.2 m/min
1.6 m/min
1.3 m/min
1.1 m/min
Under 50 μm
50 μm 100 μm
100 μm 150 μm
150 μm 250 μm
over 300 g 720 mm width
115
115
120
125
1.6 m/min
1.3 m/min
1.1 m/min
0.8 m/min
•
Proper temperature and speed may be changed on operation condition.
•
Recommend to go trial test before laminating important objects.
•
In occasion of not good adhesion, increase the temperature little bit
•
In continuous operation if it doesn’t keep the set temperature please decrease
the speed
