DVR Server Manual ver.6.05/rel.120909
19
When system runs
―Playback to TV Wall‖ process, the Matrix card will
output recording data. If this process does not run, matrix decode card will
output real-time video according to your
. Otherwise, when
you use matrix card to decode video data from an IP Camera, you
can‘t use
this function to play back recording video data to TV Monitor but only output
real-time video of local board and IP Camera to TV Wall according to your
setting in
. In this process, you can play back record file by date
and camera, and the record file will be played automatically.
12.
Motion detect setup
By default, the entire screen is set as motion detection area which is
indicated with a green border around the entire image. To mask a specific
area, you can click the
button to cancel the full screen detection
border; then Left-Single-Click and drag/draw around the desired area. A
green rectangle will mark the area. Also, you can set any other areas. Any
activity in the motion detection areas will trigger recording, depending on the
reaction mode; and alarms may be generated along with electronic map icons
flashing in alert mode. Click
button to test the sensitivity of
motion detection. The sensitivity can be adjusted by dragging the slider bar
below the motion detection window.
Notice: motion sensitivity value will affect the accuracy of
