DVA-102ETH version 1.2
R&D Department
15
DVA-102ETH
Digital voice announcer
and Optimax system gateway
7.4.
AUDIO OUTPUT CONNECTION
Balanced analog output, with an RJ45 connector and a sensitivity of 0 dBm.
For its connection, refer to Figure 9.
Pin 1
: Audio H (Hot).
Pin 2
: Audio C (Cold).
Pin 3
: 24 V DC input. Provides the EMERGENCY INPUT
with a phantom power supply, even when the DVA-
102ETH is not powered.
Pin 6
: Output priority contact. It is activated:
when a Compact Flash message from the DVA-
102ETH is played,
when the priority contact of the AUDIO INPUT is activated,
when priority digital audio is received through the ETH A or B inputs,
when an input contact configured as
Local message activation
is activated.
Pin 8
: GND.
7.5.
INPUT CONTACTS
CONNECTION
The unit has 19 input contacts, which can be
configured by means of the P.A. Manager
software.
To activate a contact, this contact must be
grounded.
These inputs are used for:
Local pre-recorded message activation:
When the input contact is activated, a pre-
recorded message is sent from the DVA-
102ETH to one or several zones.
Zone selection: When the input contact is
activated, a destination zone is pre-
selected. When the priority of the AUDIO
INPUT is activated, the signal applied to the
AUDIO INPUT will be sent to this zone.
7.6.
OUTPUT CONTACTS CONNECTION
The unit has 19 output contacts, which can be configured by means of the P.A.
Manager software.
They are open collector outputs, as shown in the diagram in Figure 11. These
outputs can be used, for example, to activate analog zones, to select zones of an
MC12/24L, to activate the priority of external devices, to light a LED…
Figure 11
Figure 9
Figure 10
. Example of input contacts connection for activation of pre-
recorded messages from the DVA-102ETH.
Figure 11
