Optimum OPTIturn TX 6222, Руководство по эксплуатации

Страница: 52 / 124

Operation
Version 1.0.1 dated 2017-11-16 Page 52 Translation of the original instructions
TX6222 GB
T
X
6222
_GB
_4.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
4.22 Thread cutting
4.22.1 Module and D.P. threads
INFORMATION
In countries where the Anglo-American system of measurement is used, its inverse is used as a
"diametrical pitch" (D.P.) with the unit 1 inch instead of the module.
4.22.2 Thread cutting
The thread cutting in longitudinal direction is carried out with the lead screw.

Set the desired pitch.

Set the engaging lever (5) for thread-cutting on apron to the down position (lead screw nut
closed). The engaging lever for longitudinal and cross feed (feed rod) (8) on apron must be
set to the neutral middle position.
INFORMATION
Due to a safety mechanism, it is not possible to use the

longitudinal feed via the lead screw and

cross feed / longitudinal feed with feed rod
at the same time.
The thread cutting process requires that the operator has a good knowledge of turning and suf-
ficient experience.
NOTES!
Example of an external thread:

The workpiece diameter must have been turned to the diameter of the desired thread.

The workpiece requires a chamfer at the beginning of the thread and an undercut at the
thread run out.

The speed must be as low as possible.

The thread cutting tool must be exactly the same shape as the thread, it must be absolutely
rectangular and must be clamped in a way that it coincides exactly with the turning centre.

The threading engaging lever must be engaged during the whole thread cutting process.
This does not apply to thread pitches that can be carried out with the thread gauge.

The thread is produced in various cutting steps in a way that the cutting tool has to be
turned out of the thread completely (with the cross slide) at the end of each cutting step.

The tool is withdrawn with the lead screw nut engaged and the thread cutting tool disen-
gaged by actuating the "Direction of rotation control lever".

Stop the lathe and feed the thread cutting tool in low cut depths using the cross slide.

Before each passage, place the top slide approximately 0.2 to 0.3 mm to the left and right
alternately in order to cut the thread free. In this way, the thread cutting tool cuts only on
one thread flank with each passage. Do not execute any more free cutting, just before
reaching the full thread depth.
Module =
25.4
D.P.