31
• Please keep the cuff clean. Clean the cuff by wet soft cloth and mild detergent if the cuff
becomes dirty. Do not remove the cuff from the monitor.Clean the cuff after the usage of
every 200 times is recommended.
• Do not place the cuff around your wrist if the wrist has any inflammation, acute diseases,
infections skin wounds.
5. BODY POSTURE DURING MEASUREMENT
Sitting Comfortably Measurement
a. Be seated with your feet flat on the floor, and don’t cross your legs.
b. Place palm upside in front of you on a flat surface such as a desk or table.
c. The middle of the cuff should be at the level of the right atrium of the
heart.
6. TAKING YOUR BLOOD PRESSURE READING
a. After applying the cuff and your body is in a comfortable position, press
the “START/STOP” button. All display characters are shown for self-test.
You can check the LCD display according to the right picture. Please con-
tact the service center if segment is missing.
b. Then the current memory bank
or is displayed. Press “MEM” button to change
over to other bank. Confirm your selection by pressing “START/STOP” button. The current
bank can also be confirmed automatically after 5 seconds with no operation.
c. Then the monitor inflates the cuff until sufficient pressure has built
up for a measurement. Then the monitor slowly releases air from the
cuff and carries out the measurement. Finally the blood pressure and
pulse rate will be calculated and displayed on the LCD screen. The blood
pressure classification indicator and Irregular heartbeat symbol (if any)
will blink on the screen. The result will be automatically stored in the monitor.
d. After measurement, the monitor will turn off automatically after 1 minute of no operation.
e. During measurement, you can press the “START/STOP” button to turn off the monitor ma-
nually.
Note:
Please consult a health care professional for interpretation of pressure
measurements
.
7. DISPLAYING STORED RESULTS
a. In StandBy Mode, press “MEM” button, the monitor will display sign of current group. Press
“MEM” button to switch group, press “START/STOP” to confirm current group.Then the amo-
