28
26. Swallowing batteries and/or battery fluid can be extremely dangerous. Keep the batteries
and the unit out of the reach of children and disabled persons.
27. If you are allergic to plastic/rubber, please don’t use this device.
SETUP AND OPERATING PROCEDURES
1. BATTERY LOADING
a. Open battery cover at the back of the monitor.
b. Load two “AAA” size batteries. Please pay attention to polarity.
c. Close the battery cover.
When LCD shows battery symbol
, replace all batteries with new ones.
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid relevant
damage of battery leakage.
Avoid the battery fluid to get in your eyes. If it should get in your eyes, immediately rinse
with plenty of clean water and contact a physician.
The negative terminal of the battery needs to be compressed into the battery compart-
ment properly after horizontal compression of the negative electrode. The battery is in
contact with the spring.
Make sure the battery cover is intact and not damaged before installing the battery.
The monitor, the batteries and the cuff, must be disposed of according to local regulations
at the end of their usage.
2. CLOCK AND DATE ADJUSTMENT
a. At first the Blood Pressure Monitor is totally off, once you insert the battery, the Blood Pressure
Monitor will enter Clock and Date Adjustment Mode.
b. If the time of the device is already set and need to be changed, adjustment can be reached by
pressing both the “START/STOP” and “MEM” button for 3 seconds in Standby Mode.
c. In Clock and Date Adjustment Mode , the time format will blink at first, see picture 2-1 the
default time format is 24 h and the default clock and date is 2019-1-1 1:00.
d. Press the button “START/STOP” repeatedly, the year (first usage: default is 2019, range is
2019~2099), month, day, hour and minute will blink in turn, see picture 2- 2 & 2-3 & 2-4 &
2-5 & 2-6. While the number is blinking, press the button “MEM” to increase the number, keep
on pressing the button „MEM”, the number will increase faster.
e. During adjusting clock and date, the monitor will go back to Standby Mode automatically
when no button will be pressed within 30 seconds.
f. You can turn off the monitor by pressing “START/STOP” button when the minute is blinking,
then the time and date is confirmed.
