OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.0.4 dated 2015-11-19
Page 23
Original operating instructions
DRO 5
GB
Setting counting direction
Press the "PROG" key to enter the menu. “+/-“ as a select.
Setting display mode
Press the "PROG" key to enter the menu. "On / Off" as a select.
Linear error compensation
Press the "PROG" key to enter the menu, use
↑
↓
←
→
keys to modify, then press the "PROG" key to exit.
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to section 5.1.2
INFORMATION
The parameter setting of Y, Z-axis is the same as X-axis.
5.1.4 Parameter setting of speed axis
Teeth amount of every turn (pulses per rev)
Press "PROG" key to enter, selection range is 1~36, the increment or decrement is 1.
Display mode
Press the "PROG" key to enter the menu, "On / Off" as a select.
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to section 5.1.2
5.2
Magnetic sensor and magnetic strip
5.3
Mechanical installation
Installation may only be carried out in accordance with the specified IP protection. If necessary the system
must be protected against environmental influences, such as sprayed water, solvent, dust, shocks, vibra-
tions, temperature fluctuations.
5.4
Installation magnetic strip
The mounting surface / measuring track must be flat. Buckles or bumps will lead to measuring inaccuracies.
For technical reasons the strip should be approx. 30mm longer than the actual measuring distance.
ATTENTION!
For an optimum of adhesion, all anti-adhesive substances (such as oil, grease, dust etc.) must
be removed by using residue-free (=evaporating) cleaners. Suitable cleansing agents are e.g.
ketones (acetone) or alcohols; Messrs.octite and 3M can both supply such cleansing liquid. Make
sure that the surface to be glued is dry and apply the stop with maximum pressure. Glueing should
preferably be undertaken at temperatures between 20° to 30° Celsius and in dry atmosphere.
INFORMATION
When applying long pieces of magnetic strip do not immediately remove the complete protective foil,
but rather peel back a short part from the end sufficient to fix the strip. Now align the strip. As the protective
strip is then peeled back and out, press the tape firmly onto the mounting surface. (a wallpaper roller wheel
could be used to assist in applying pressure onto the magnetic strip when fixing it in position)
