Version 1.1.2 - 2022-02-24
65
Translation of original instruction
S 131 GH
EN
S131
GH_GB
_3.
fm
3.4.5
Mounting the V-belt housing
Mount the V-belt housing on the metal band
saw. To do so, use the fixing material
included in the delivery.
Img.3-7:
Assembly V-belt housing
3.4.6
Mounting the V-belt
Place the V-belt in the required position on
the pulleys.
Img.3-8:
Assembly V-belt
Tighten the V-belt with the tensioning screw
and Allen screw on the motor.
Check the tension in the V-belt. The tension
in the V-belt is correct if you can push it
approximately 1 cm with your finger.
Close and screw down the protective cover.
Img.3-9:
Tension V-belt
INFORMATION
As long as the protective cover is not closed it is not possible to start the machine.
ATTENTION!
Watch for the proper tension of V-belts. Too heavy or too low tension of the belt can
cause damage.
3.5
First commissioning
WARNING!
When first commissioning the metal band saw by inexperienced staff you endanger
people and the machine.
We do not accept any liability for damages caused by incorrectly performed
commissioning.