Safety
Version 1.1.8 dated 2018-9-13
Page 65
Translation of the original instructions
B16H | B16HV
GB
B16H_B
16HV_
GB_
1
.f
m
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
B16HV
Switch off the bench drill by pressing the
main switch and secure the main switch
against restarting by pulling off the
safety bar from the main switch and
keeping it in a secure place.
It is only possible to restart the machine
after having plugged in the safety bar.
All machine parts as well as any dan-
gerous voltages are switched off.
Img.1-7:
Main switch B16H
Excepted are only the positions which are marked with the adjoining pictogram.
1.16.2 Using lifting equipment
WARNING!
The use of unstable lifting and load suspension gear that might break under load can
cause severe injuries or even death.
Check that the lifting and load suspension gear
they have sufficient load carrying
and that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other competent supervisory authority, responsible for your
company.
Fasten the loads properly. Never walk under suspended loads!
1.16.3 Mechanical maintenance work
Remove or install protection and safety devices before starting any maintenance work and re-
install them once the work has been completed.This includes:
Covers,
Safety indications and warning signs,
earth (ground) connections.
Check if they are working properly!
1.17
Accident report
Inform your superiors and Optimum Maschinen Germany GmbH immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are notified, the faster the causes can be eliminated.
1.18
Electrical system
Have the machine and/or the electrical equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
Define and document the inspection deadlines for the machine in accordance with § 3 of the
Factory Safety Act and perform an operational risk analysis in accordance with § 6 of the Work
Safety Act.
Main switch
Safety bar
