OPTIMUM Maschinen 3003161, Руководство по эксплуатации

Страница: 54 / 70

Operation
Version 1.0 2019-01-17 Page 54 Translation of the original instructions
B17Pro basic GB
B17P
ro_b
asic_
G
B.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
4.5.2 Fitting the drill chuck
The drill chuck is secured in the drill spin-
dle against turning over by means of a
form-locking connection (driver).
A frictionally engaged connection keeps
and centres the drill chuck or the drill in the
drill spindle.
Img.4-2: Taper mandrel

Check and clean the conical seat in the drill spindle and on the taper mandrel of the tool or
drill chuck.

Press the taper mandrel into the drill spindle.
4.6 Cooling
The friction generated during rotation can cause the edge of the tool to become very hot.
The tool should be cooled during the drilling process. Cooling the tool with a suitable
cooling lubricant ensures better working results and a longer edge life of the tools. This is best
realised by a separate cooling equipment. If there is no cooling equipment included in the deliv-
ery volume, you can cool by means of a spray gun or a washing bottle.
ATTENTION!
Danger of injury due to brushes getting caught or pulled in. Use a spray gun or a
washing bottle for cooling.
INFORMATION
Use a water-soluble and non-pollutant emulsion as a cooling agent.This can be acquired from
authorised distributors.
Make sure that the cooling agent is being collected.
Respect the environment when disposing of lubricants and coolants.
Follow the manufacturer’s disposal instructions.
4.7 Before starting work
Before starting work, select the desired speed. It is depending on the used drilling diameter and
on the material.

"Speed variation“ on page 52
WARNING!
For drilling jobs, it is necessary to clamp the workpiece firmly to prevent the bit catching
on the pieces. A machine vice or clamping claws is a suitable clamping device.
Put a wooden or plastic board beneath the workpiece to avoid drilling through to the work table,
vice, etc.
If required, adjust the desired drilling depth by means of the drilling depth stop in order to obtain
a uniform drilling depth.
Please make sure to use a suitable dust suction when treating wood since wood dust may be
health hazardous. Wear a suitable dust mask when performing works at which dust is gener-
ated.
Drill sleeve
Opening for the
Drill drift
Drilling spindle
Driver
Taper mandrel