Page 9
3-2-3 Installing the stage extension and the mechanical stage (fig. 6)
(Not included in LT version)
The stage extension can be installed on either side of the stage to en
-
large the working surface. The mechanical stage must be installed on
the side opposite the extension.
For right-handed operators, the mechanical stage is normally installed
on the right side.
1.
Installing the stage extension: Screw the bolts (1) on to the extension,
then mount the extension from below the stage. Screw it to a firm fit.
2.
Installing the mechanical stage: As for the extension, the mechanical
stage is fixed by two bolts under the stage.
3-2-4 Installing the stage insert (fig. 7)
1.
When using the glass stage (1), make sure that the stage is horizontal.
2.
Install the stage insert in the stage opening.
Turn the disk until the V-groove faces the user. This simplifies objective
identification.
3-2-5 Installing the eyepieces (fig. 8)
1.
Remove the cap of the eyepiece tubes (1).
2.
Insert the eyepieces (2) into the tubes.
3-2-6 Installing the color filters (fig. 9)
► Be sure the color filter has cooled down completely before you
change them. Remove the filter holder (1), then install the color
filters (2) you need.
Mount the color filter flat as shown in (3), verifying that they are not
tilted.
► If the color filter is tilted or otherwise out of place (4), it may fall.
The color filters can be stacked in the holder. This allows to install as
many filters as needed, as long as the whole thickness is less than 11
mm.
3.0 INSTALLATION
1
2
3
4
Figure 6
Figure 9
Figure 8
Figure 7
1
1
1
2
2
1
4
3
