Biopel MINI - Installation and Operation Instructions
15
6.1.2.
Tower hopper
Disconnect the display cable using a small screwdriver.
The feeder cable is factory coiled and laid on the boiler
control unit. Access the control unit by removing the top
orange cover, which is fixed to the boiler by 2 screws.
After loosening the screws, then pulling backwards and then
upwards, carefully remove the orange cover and pull the
feeder cable through to the rear of the boiler, as shown in
the picture.
Caution! There is a switch and fuse attached to the orange
boiler cover. Remove the cover carefully to avoid damaging
the cable.
Feeder motor with
socket
Hopper lid with
seal
Display holder
Feeder outlet
Rear orange cover can
be removed
Straight burner pipe
Disconnect the connector
on the back of the display
