OPHIR BeamSquared, Руководство пользователя

Страница: 107 / 112

D.2 SP920
Supplied Accessories D.2.1
The SP920 is supplied with the following accessories:
 USB3.0 Certified Standard-A to Micro-B cable

Coax External Trigger Cable – Hirose HR25-7TP-8P(72) to BNC
o
Pins 2 & 5 – External Trigger, SMA Bulkhead, Female
o
Pins 1, 3, 4, & 6 – Not connected, see reference table
External Trigger Control D.2.2
The SP920 camera is supplied with an external trigger input cable. The input to this cable should be a
standard TTL level positive going pulse. The camera triggers, and begins integrating light on the rising edge. A
trigger pulse should be at least 5μs in duration.
To operate in external trigger mode you must set the trigger control to In . Select Off when operating in CW
mode.
GPI/O Connector Description D.2.3
The camera is equipped with a 6-pin GPIO connector on the back of the case. The connector is a Hirose
HR10A-7R-6PB, the mating connector is a Hirose HR10A-7P-6S(73).
This section contains reference material that has been reproduced with minor modifications as it was provided in the FLIR Blackfly USB3 Vision
Technical Reference by FLIR Integrated Imaging Solutions, Inc. All information is assumed to be accurate at the time of writing. No assumption of
copyright is made on such material; all rights are retained by the original author.