OpenEye CM-510, Руководство по установке, Страница: 16 / 37

6 28582AA
DOME SETUP
Before connecting the dome camera to CCTV devices, please complete the dome ID and communication switch settings. These
switches are located on the bottom of the dome camera.
Switch Definition
Please refer to the following figure for switch location and definitions.
Communication Switch Setting
The table below shows the function of each switch with the Communication Switch.
Communication Switch SW1
RS-485 Setting
SW2
SW3 Termination
SW4 Line Lock
SW5 System Initialization
SW6
Reserved
RS-485 is the interface that the dome camera uses to
communicate with its control device; for this reason, the RS-485
setup of the dome and the control device must be the same. The
RS-485 default setting is half-duplex (see the diagram right). Do
not change the default setting without a qualified specialist or
supplier’s notice. As for the SW 3 and SW 4, they are used for
termination and Line Lock adjustment respectively. The SW 5 is
mainly used when users want to restore the camera to the
factory default status; additionally, after a firmware upgrade is
carried out, users must reset the SW 5.
RS-485 Setting
Half-duplex Full -duplex
Reserved
Communication
Switch
Dome Control Protocol Switch
ISP Connector
(for firmware upgrade)
Dome ID Switch
22-pin Connector