45
Flush System
The flush system is designed and built to rinse waste from holding tank
AFTER waste tank has been drained completely of water and solids.
Attach a fresh water base connection marked “San-a-flush.” Be sure
termination valves are open on holding tank(s).
Open valve to release water into tank for rinsing and cleaning of your
waste holding tank.
Rinse for several minutes to remove any foreign matter from tank.
Remember the moisture content may give you a false reading on your
monitor panel indicating it is full. Allow time to dry out tank or recharge
for next usage.
Lo-Point Drains
Water storage tanks and water heaters have their own drains, as
previously mentioned. For line plumbing system these drains are placed
at the lowest area of water line to release liquids. By locating 2 short water
lines below coaches, usually inches apart, and capped off.
Some models may have the outside shower assembly placed below floor
level and used as the “lo-point” drain.
