9
Owner’s guide
Rev. 1.3
Sequence number Button name
Function
1
Volume up
To increase the volume. This is basically the same as
pressing the volume offset button on the front of the
speaker.
2
Volume down
To decrease the volume. This is basically the same as
pressing the volume offset button on the front of the
speaker.
3
Power on/off
To control the power state.
The buttons are learned in sequence starting from 1 in above list. You don’t need to learn buttons
for all functions as the learning function can be deactivated at any time.
The IR learning function is activated this way:
1.
Make sure the unit is ON
2.
Now press and hold the Standby button for more than 2 seconds
3.
The LED now flashes white.
4.
Now press the BT pair button for less than 2 seconds. When IR learning is activated the
status LED starts flashing yellow.
Learn a command:
5.
Point your remote toward the IR eye. It’s in the center of the control panel on right side
speaker (above the LED).
6.
Press the button you want to learn once and observe the LED:
a.
Steady green -> OK.
b.
Steady red -> Command was NOT learned.
7.
Wait until the LED flashes yellow again and then repeat for next button to be learned or
retry the learning of the button which just failed. In either case repeat from step 5.
Done learning:
8.
If buttons for all 3 functions was learned the system will automatically reboot and return to
normal operation mode. If you only want to learn some commands, you simply terminate
the learning function by pressing the BT pair button for less than 2 seconds when done
learning the commands you need.
7.5 Source select
The Opalum Furniture Sound System doesn’t require any source select. Instead sources are
priorities and will start playing accordingly. The priorities are as follows:
1.
Bluetooth
2.
Analog
3.
Digital optical (will only play if nothing is connected to the analog input)
4.
Digital coax (will only play if nothing is connected to the analog input and no signal on
digital optical input).
