10
Owner’s guide
Rev. 2.3
The buttons are learned in sequence starting from 1 in above list. You don’t need to learn buttons
for all functions as the learning function can be deactivated at any time. However, if you for
instance want to learn the button for “Source next”, you will also need to learn buttons for
“Volume up” and “Volume down”, but not “Power on/off”.
The IR learning function is activated this way:
1.
Make sure the unit is ON (if not push the master volume switch)
2.
Press the IR Learn/Reset button in the bottom of the control hub for 2 seconds
3.
When IR learning is activated the status LED starts flashing yellow
Learn a command:
4.
Point your remote toward the IR eye in the front left side of the Control Hub (just to the
right of the LED). Press the button you want to learn once and observe the LED:
a.
Steady green -> OK.
b.
Steady red -> Command was NOT learned.
5.
Wait until the LED flashes yellow again and then repeat for next button to be learned or
retry the learning of the button which just failed. In either case repeat from step 4.
Done learning:
6.
If buttons for all 4 functions was learned the Control Hub will automatically reboot and
return to normal operation mode. You can terminate the learning function by pressing the
IR Learn/Reset button for 2 seconds again.
7.3 Source select (learned IR remote only)
Using the learned IR buttons; source can be selected by stepping through the sources one by one.
The sequence of sources is:
7.5 Power on/off (learned IR remote only)
Using the learned IR buttons; the Opalum sound system can be switched ON and OFF. If the
system is manually switched OFF, the automatic wakeup is disabled.
Mixer
(White)
Digital
Optical 1
(Dark Blue)
Digital
Optical 2
(Pink)
Digital
Coaxial
(Yellow)
Analog
(Light Blue)
Bluetooth
(Orange)
