Onlogic Factor 202, Руководство по эксплуатации продукта

Страница: 37 / 39

53 NC NC 54
55 NC NC 56
57 GND NC 58
59 NC NC 60
61 NC NC 62
63 NC NC 64
65 NC NC 66
67 RESET_N SUSCLK 68
69 CONFIG_1 3.3V 70
71 GND 3.3V 72
73 GND 3.3V 74
75 CONFIG_2
6.6 Appendix E: Safety Information
Do not open or modify the device. The device uses components that comply with FCC and CE
regulations. Modification of the device may void these certifications.
6.6.1 Safe Use and Installation Instructions
1. Install the device securely. Be careful handling the device to prevent injury and do not drop.
2. Wall or ceiling mounting the device requires use of a mounting plate or bracket. The plate or
bracket must be of metal construction and have a minimum thickness of 1mm.
3. Use M4x0.5mm Flat Head screws to attach mounting plate or mounting brackets to threaded
holes on bottom or rear of chassis. Screws should be a minimum length of 4mm. Add 1mm
of screw length for every mm of additional thickness of plate or bracket beyond 1.5mm.
4. Ambient operating temperature must be between 0 °C to 60 °C with a non-condensing relative
humidity of 10-90%.
5. The device can be stored at temperatures between -10 °C to 85 °C.
6. Keep the device away from liquids and flammable materials.
7. Do not clean the device with liquids. The chassis can be cleaned with a cloth.
8. Allow at least 2 inches of space around all sides of the device for proper cooling. It is
recommended to mount the device such that the metal side plates are vertical to allow air to
rise unobstructed. Alternative orientations may result in reduced operational temperature
range.
9. This device is intended for indoor operation only.
10. Use only antennas provided. Maintain 20cm of distance from the antenna.
11. Use UL Listed external power supply with rated output 12Vdc
12. Install the device only with shielded network cables.
13. Only use SAE approved cables for automotive installation.
14. The installer should be experienced in aftermarket installation and familiar with general
practices for installing electronics devices in vehicles.
15. The device should not be installed in the driver’s area of a vehicle.
37