28
En
You can switch inputs to select the desired source
component. Choose an input from the following:
LINE1
,
LINE2
,
LINE3
,
COAX1
,
COAX2
,
OPT
,
PHONO
■
Operating with the remote controller
■
Operating on the integrated amplifier
Tip
• For changing the input’s name, see “Changing Input Names”
(
➔
page 35
).
• To hide the display of unused inputs, see “Skipping Unused
Inputs” (
➔
page 36
).
You can adjust the brightness of the integrated amplifier’s
information display.
Note
• When using the integrated amplifier’s remote controller to
operate
u
-connected components, their display brightness can
only be adjusted in 2 levels.
By bypassing the tone control circuit, the Direct function
uses the shortest path for enhanced sound quality.
Although this function generally turns the display off, the
integrated amplifier makes use of a display that doesn’t
affect the sound quality. It is therefore possible to turn the
display on while the Direct function is enabled. Also,
since the left/right balance setting uses a system that
doesn’t affect the sound quality, the balance can be
adjusted even if the Direct function is enabled.
Tip
• To turn the information display on while the Direct function is
enabled, press
DIMMER
on the remote controller.
Selecting the Input Source
1
Press
INPUT
!
/
"
repeatedly.
1
Use the
INPUT
selector.
Adjusting the Display Brightness
INPUT
!
/
"
INPUT
selector
DIMMER
1
Press
DIMMER
repeatedly.
Normal
↔
Dim
Using the Direct Function
1
Set the
DIRECT
switch to the
ON
position.
The information display goes off and the
DIRECT
LED lights.
Normal
Dim
DIRECT
LED
DIRECT
switch