
Quick Start Guide
Ceramic Fan Heater
1. Place heater on a flat surface ensuring there
is at least 30cm clearance all around and
over the top of the heater. Do Not place
items on or against the heater.
2. Insert Plug into Power Point and switch on.
3. Turn the Thermostat control down
(anticlockwise) until you hear it click off.
4. Rotate the Heat Selector switch to position:
for Fan Only
“I” for Low Heat
“II” for High Heat
“O” for OFF
5. With the Heat Selector Switch set to either “I”
or “II”, turn the Thermostat control up slowly
(clockwise) until you hear it click On. The
heater will now start to heat. Adjust up or
down to your desired temperature setting.
Note: As the
thermostat
maintains room
temperature it
will switch on
and off.
As it switches
on and off, you may notice a blue flash from
inside the heater. This is NOT dangerous and
is no cause for alarm.
6. Do not operate while unattended.
Turn the selector switch to position “O” (off)
then Turn power off and Unplug.
Always Unplug when not in use.