Page 21
For technical questions, please call 1-800-444-3353.
Item 69893
Gable and Crown Installation Instructions
Note:
Leave Bolts (65) finger tight
until step 5 of this phase.
1. Use 1 Normal Bolt (65) each to attach the
Front Gable Posts (20-23) to the outside top
of the Front Ceiling Plates (24, 25) in the
positions shown on facing page. The bottoms
of the 2 outer Front Gable Posts (22, 23)
will be secured using the Normal Bolts (65)
already in place. The sloped ends of the
Posts must be on the top and slant upward
toward the center of the greenhouse.
2. Insert 2 Normal Bolts (65) into the slot in
each Rear Gable Post (18, 19), and use
those Bolts to attach them to the top 2 holes
of the Post Connectors (48) on the outside.
Once again, the sloped ends of the Posts must
be on the top and slant upward toward the
center of the greenhouse. The bottoms of those
Rear Gable Posts (18, 19) must be pressed
down flat against the tops of the Side Posts (14).
Note:
The only difference between Right-
and Left-Handed Crown Beams is the
location of the holes.
The Beam edges with 3 drilled holes should
align with the Side Ceiling Plate (12, 13) and
the edges with 4 holes should point down.
3. Attach the Right- and Left-Handed
Crown Beams (8, 9) to the Greenhouse using
5 Normal Bolts (65) for each Beam.
The angled edges should meet at
the top of the roof.
The Beams are placed on the
outside
of the Ceiling Plates (12, 13) and
the Corner Brackets (49) and on the
inside
of the Posts (16-23).
4. Assemble the Front Crown (11) to the
Rear Crown (10) using a Straight Bracket (83),
a Crown Bracket (84), and 12 Normal Bolts (65).
See illustrations at bottom of page.
5. Press the Crown Beams (8, 9) down against
the tops of the Posts (16-23) while tightening
all Bolts (65) to secure them in place.
Crown (10, 11)
Right-handed
Crown Beam (8)
Left-
handed
Crown
Beam (9)
(View from underneath.)
6. With assistance, raise the completed
Crown (10, 11) up underneath the tops of the
Crown Beams (8, 9), and bolt it in place on
each end to the bottom of the Beams using
2 Normal Bolts (65) as shown above.
7. Attach an End Cap (72) to the top outer
corner of each Crown Beam (8, 9).
Edge-on view
Top-right view
Top-left view
Crown Beam Assembly
Содержание 69893
Страница 1: ......
