Page 17
For technical questions, please call 1-800-444-3353.
Item 69893
Post Installation Instructions
Note:
All Posts (14, 16, 17) in this
phase require extra Bolts to be
inserted into their slot before
assembly. The small numbers under
the main part number on the facing
page are the type and number of
hardware. See the examples below:
14
66,78,66
17
66(x2)
Post Part Number
Inserted Bolt
Part Numbers
Meaning:
Insert 2 Brace
Bolts (66) into the
Rear Right Post (17)
before attaching it.
Meaning:
Insert a Brace
Bolt (66), then a Double
Brace Bolt (78), then
another Brace Bolt (66)
into this Side Post (14)
before attaching it.
1. Loosen a Bolt on one of the Side Floor
Plates (3,4) in an attachment location
as shown. Slide the slot in a Side
Post (14) over the head of that Bolt.
2. Insert the required Bolts (See note
above and illustration on facing page)
into the slot in the Side Post.
3. Attach the top of the Side Post (14)
to the Ceiling Plate (12, 13), using a
Normal Bolt (65) in the slot or using the
Bolt already in place for the center Post.
4. Repeat above steps for all 10 Side
Posts (14) on the left and right
sides of the greenhouse.
5. Slide a white Bushing (81) over all 4 inserted
Double Brace Bolts (78). Place the center
hole of each Side Diagonal Strut (80)
over the end of each Double Brace
Bolt and secure with a Nut (67).
6. Loosen a Bolt on the Rear Floor Plate (5, 6)
in a location that a Side Post (14)
attaches, and slide a Side Post over
the head of that Bolt. Insert 4 Brace
Bolts (66) into the slot of that Post.
7.
(View from outside greenhouse.)
66
66
48
31
31
14
Side Post (14) must extend
no farther than halfway up
the Post Connector
(48).
Remove the 2 Brace Bolts (66) connecting
the Post Connector (48) near that
Side Post. Slide the heads of those
Bolts into the Side Post and insert them
through the Post Connector. Align the
top of the Post with the
center
of the
Connector as shown above, and press it
in place. Reattach the Rear Braces (31)
to the Brace Bolts (66) and secure them.
8. Repeat steps 6 & 7 for another
Side Post (14) and Post Connector (48).
9. Loosen the Bolts (66) where the Rear
Diagonal Struts (79) connect to the
Rear Floor Plate (5, 6). Slide the slot
in the Rear-Left Post (16) over the
head of the
left
Bolt and the Rear-
Right Post (17) over the
right
Bolt.
10. The slanted ends of the Posts must be
on top and slant towards the center of
the greenhouse. Retighten the Bolts.
11. Slide 2 Brace Bolts (66) into the
slot of each Rear Post (16, 17).
12. Slide one more Brace Bolt (66) into the top
of each Rear Post. Attach the Rear Posts
to the Rear Braces (31) using those Bolts.
13. The frame should now rest square.
Measure diagonally from corner to corner
at the top. If the measurements are
not equal, adjust the frame as needed
until square. Some Nuts (67) may need
to be loosened to adjust the frame.
Tighten all Nuts after adjustment.
Содержание 69893
Страница 1: ......
