O
WNER
’
S
M
ANUAL
Checking the Codes
9
NOTE:
In the search mode, the remote control
will send IR codes from its library to the
selected device, starting with the most
popular code first.
5.
To lock in the code, press and release
SET
. The LED will blink twice.
6.
To search for the codes of your other
devices, repeat steps 1 through 5, but
substitute the appropriate device key
for the device you are searching for.
CHECKING THE CODES
If you have set up the remote control using
the
Searching For Your Code
procedure (on
the previous page), you may need to find
out which four-digit code is operating your
equipment.
For example, to find out which code is
operating your TV:
1.
On the remote control, press
TV
once.
2.
Press and hold
SET
until the LED (red
light) blinks twice, then release
SET
.
3.
Enter
9 9 0
. The LED will blink twice.
4.
To view the code for the first digit,
press
1
once. Wait 3 seconds, count the
LED blinks (e.g., three blinks =
3
) and
write down the number in the leftmost
box in the
TV
code boxes on page 7.
NOTE:
If a code digit is
0
, the LED will not
blink.
5.
Repeat step 4 three more times for
remaining digits. Use
2
for the second
digit,
3
for the third digit, and
4
for the
fourth digit. Write down the code
digits in the remaining TV code boxes
on page 7.
6.
To check for codes of other devices,
repeat steps 1 through 5, but substitute
the appropriate device key for each
device you are checking. Write down
the device’s code digits in the
appropriate code boxes on page 7.
PROGRAMMING MASTER
POWER
In its default state, the
POWER
key on the
URC-6131 remote control will individually
power your home entertainment devices on
or off. However, you can also program a
Master Power
function onto the
POWER
key
that will sequentially turn on or off all the
devices with a single key press.
P
ROGRAMMING
THE
POWER K
EY
FOR
M
ASTER
P
OWER
1.
Press and hold
SET
until the LED (red
light) blinks twice, then release
SET
.
2.
Enter
9 9 5
. The LED will blink twice.
Then press
POWER
once.
3.
For the first device you want in the
power on sequence, press its device
key (e.g.,
CBL/SAT
) once.
4.
Repeat step 3 up to five more times to
add desired devices to the power-on
sequence.
5.
To save the settings and exit the
program, press and hold
SET
until the
LED blinks twice, then release
SET
.
O
PERATING
M
ASTER
P
OWER
1.
After programming, point the remote
control at the devices and press
POWER
for at least 2 seconds to sequentially
turn on or off your devices.
NOTE:
When you press
POWER
for less than 2
seconds, the remote will only send a power
command to the currently-selected device.
This allows you to still individually power
devices on or off.
PVR 6 Owners Manual.fm Page 9 Monday, December 20, 2004 11:17 AM
