2.
Enter
9
-
9
-
5
. The LED will blink twice.
Then press
POWER
once.
3.
For the first device you want in the power
on sequence, press its device key (e.g.,
CBL/SAT
) once.
4.
Repeat step 3 up to five more times to add
desired devices to the power-on sequence.
5.
To save the settings and exit the program,
press and hold
SET
until the
LED
blinks
twice, then release
SET
.
Operating Master Power
1.
After programming, point the remote
control at the devices and press
POWER
for at least 2 seconds to sequentially turn
on or off your devices.
NOTE: When
POWER
is pressed for less than
2 seconds, a power command will only be sent
to the currently-selected device. This allows you
to still individually power devices on or off.
2.
You will see the devices turn on or off
according to your programmed sequence.
NOTE: The currently-selected device will always
turn on first, followed by the remaining
programmed sequence. After the master power
sequence has been completed, the remote control
will be set to control the first powered-on device.
NOTE: If one or more devices does not have a
POWER
key, the power off/on sequence may be
slightly delayed when the remote control signals
the device(s). This action is normal.
Clearing Master Power
1.
Press and hold
SET
until the
LED
(red light)
blinks twice, then release
SET
.
2.
Enter
9
-
9
-
5
. The LED will blink twice.
Then press
POWER
once.
3.
Press and hold
SET
until the
LED
blinks
twice, then release
SET
. Master Power is
now cleared.
13
OFA 6 PVR 2/15/03 9:25 AM Page 13