Once AgriShift LCL-0.2-120V, Инструкция по установке и эксплуатации

Страница: 8 / 40

AgriShift
®
Lighting Control Unit MASTER - Model LCL-0.2
6
SEC
TIO
N 2
2.4 INSTALLATION
It is essential to observe the following installation instructions and to abide
by the applicable local electric codes:
1. The controller is designed for wall mounting and must be installed
vertically.
2. The heat generated by the modulation circuit is released by the heat sink
located on the back of the device. Therefore, it is important to ensure
that there is no obstacle hindering or interfering with the free passage
of air 20 cm (8 inches) above and 10 cm (4 inches) under the controller.
3. Moreover, the controller must never be installed over a heat source such
as a radiator or other controller with a heat sink.
4. The controller must be installed in a location protected from harmful
gases or excessive moisture. It should never be sprayed directly.
5. Temperature at the installation site of the controller must lie between
0 º and 40 º C (32 º to 104 º F) at all times.
6. Relative humidity at the installation site of the controller must lie
between 5% and 90% at all times.
7. Low voltage wiring (control signals, sensors and potentiometers) must
be isolated from high voltage ones.
8. It is absolutely mandatory to connect the ground wire to the space
provided for this purpose. Improper grounding could lead to
malfunction.
9. The installation wall of the controller must be even and able to with-
stand a temperature of 80 º C (180 ° F). The controller should never be
installed directly on a wall made of styrofoam, urethane or other heat-
sensitive materials.
10. The controller must be checked regularly to ensure its proper operation.
In case of failure, identify the fault symptoms and contact the product
supplier.
2.5 POSITIONING
It is strongly recommended to install the controller in a location accessible
and at eye level in order to facilitate its installation, use and maintenance.