STAND: 17.06.2019
9910_Operation_Manual_STANDGUARD_G1_Rev1.2_EN
Seite 13 von 25
7 Installation
7.1 Unpacking
Note:
When unpacking, ensure ESD-compliant handling of the electronic components.
Caution:
Oelschläger
Metalltechnik
GmbH does not provide any warranty for faults
and damage to the device that are the result of electrostatic discharge.
For unpacking electronic devices, please proceed as follows:
1. Remove the packaging material.
2. Check the contents of the package for completeness:
3. Dispose of the packaging material in an environment-friendly manner, in accordance with the
applicable national regulations in your country. Recycle reusable packaging.
7.2 Installation
Assemble the table controller STAND.CONTROL C1 in accordance with the relevant instructions.
Install the sensor STAND.GUARD G1 centrally on the underside of your table. The position and
alignment of the sensor can be chosen at will. The sensor can be positioned both on/in the longitudinal
beam of the table as well as on the underside of the table top.
You need neither additional material nor tools for the installation. The sensor is already provided with
double-sided adhesive tape at the factory. Fasten the sensor with this strip of double-sided adhesive
at the desired place.
Note:
Before fitting, the control system and the sensor must be electrically
deenergised.
Note:
It is recommended that the sensor be fastened centrally below the table top.
If you wish to retrospectively upgrade the sensor on a table-top support frame, to start with, isolate the
controller from the power grid.
You need neither additional material nor tools for installing the sensor. The sensor leaves the factory
with double-sided adhesive tape. Fasten the sensor using this adhesive tape at the desired place. The
surface on which the sensor is to be stuck must be free of dust and dirt.
There is no provision for the position of the sensor to be changed retrospectively. When the sensor
gets detached from it, the adhesive tape becomes unusable and if required, has to be replaced by a
new one.
Note:
It is recommended that the sensor should be fastened centrally below the table-
top.
Connect the sensor to one of the RJ45 sockets (D1 or D2) in the STAND.CONTROL C1. Ensure that
when it is inserted, the RJ45 plugs snaps into place audibly. Check the firmness of the hold if required
by pulling lightly on the cable.
