STAND: 17.06.2019
9910_Operation_Manual_STANDGUARD_G1_Rev1.2_EN
Seite 18 von 25
10 Disassembly/Maintenance
10.1 Disassembly
1. Disconnect the controller from the mains.
2.
Separate the connections between the controller or the STAND.CONNECT Hub and the sen-
sor.
3.
Then carefully detach the glued joint between the sensor and the table-top support frame. The
double-sided adhesive tape of the sensor becomes unusable when this is done.
4.
If the sensor is to be re-used, carefully detach all the residues of the adhesive tape from the
sensor housing and replace the double-sided adhesive tape with a new one.
5.
If the table-top support frame is to be made operational again after removing the sensor, note
that the controller then first detects a sensor fault, this is indicated on a Comfort hand switch
as Code
and in addition, the controller signals the fault acoustically by going ‘click-clack’
3 times; the fault must be acknowledged by pressing any key on the respective hand switch.
Then, when a key is pressed again, the system resumes working as usual, but without the ad-
ditional protection provided by the sensor.
10.2 Maintenance
Warning:
Do not open the sensor. Opening the sensor will render all warranties from
OMT null and void.
Danger:
If you find defective cables, immediately isolate the controller from the mains.
Pull the mains plug.
Check the plug-and-connector joints at the controller regularly for firm fitting. Check all the cables
regularly for defects. If you find defective cables, plugs or loose plug-and-connector joints, replace the
cables. If that is not possible, or does not bring about any improvement, contact OMT customer
service
10.3 Cleaning and maintenance
Warning:
Aggressive cleaning agents can cause damage or discolouration on the
product. Therefore, only agents with a pH value of 6-8 may be used.
The STAND.GUARD G1 sensor can be wiped from the outside with a soft cloth. Coarse soiling may
only be removed with a soft, damp cloth. Ensure that no moisture penetrates into the housing.
