Omron V780-HMD68-EIP-JP, Руководство пользователя

Страница: 206 / 326

7 Ethernet/IP Communications
7 - 54 UHF RFID System V780-series Reader/Writer User’s Manual (EtherNet/IP
TM
) (Z402)
z Function
This command sets the time to stop the transmission power.
z Command Area
SET TRANSMISSION TIME
Signal/data Data type Size Function
CmdCode/Command Code WORD 2 bytes 300F hex
CmdParam1/Command Parameter 1 WORD 2 bytes 0000 hex (Not used.)
CmdParam2/Command Parameter 2 WORD 2 bytes 0000 hex (Not used.)
Reserved/Reserved Area WORD 2 bytes 0000 hex (Not used.)
Cnt Response/Update Counter
Response WORD 2 bytes 0000 hex (At command execution)
The value is counted up due to a change in
the update counter.
For details, refer to
Update Counter/Update
Counter Response on page 7-10.
CmdData/Command Data
Stop time
*1
*1. To specify the stop time in the JP version, be sure to specify the continuous transmission time to other than
infinite (0000 hex). A command parameter error will occur if only either one of stop time or continuous trans-
mission time is set to 0.
The stop time cannot be set to 0000 hex in models other than those for JP.
WORD 2 bytes Specifies the time to pause output during
transmission command execution.
For JP
0000 hex, 000A to 03E8 hex
(0000 hex is either None, or 10 to 1,000)
[msec]
Default setting: 0000 hex
For US
000A to 03E8 hex
(10 to 1,000 [msec])
Default setting: 000A hex
Continuous transmission time WORD 2 bytes Specifies the maximum time to continuously
output radio waves during communications
command execution.
For JP
*1
0000 hex, 0190 to 2710 hex
(0000 hex is either No limit, or 400 to 10,000)
[msec]
Default setting: 0000 hex
Other than for JP
Always 0000 hex