Omron V500-R2 Series, Руководство пользователя

Страница: 11 / 144

9
V500-R2 series
User’s Manual
In
tr
od
uc
tion
Introduction
Always observe the following precautions to prevent operation failures, malfunctions, and adverse effects
on performance and equipment.
1. Installation location
„
The product must not be installed in a place:
•
where ambient temperature is outside the range defined in the specifications,
•
where a rapid temperature change (dew condensation) occurs,
•
where ambient humidity is outside the range defined in the specifications,
•
where direct vibration or shock may affect the product,
•
where exposed to intense ambient light (laser, arc welding, or UV light),
•
where exposed to direct sunlight or heat from heating appliances, and
•
where a strong magnetic or electric field exists.
„
Because of the protection rating described in the manual, avoid using
locations containing:
•
corrosive or combustible gases,
•
dust, salt, or metallic powders,
•
droplets, water mist, oil or chemical agents.
2. Power supply, connection, and wiring
•
Be sure to use S8VS-01505 (made by OMRON) as a driving power supply.
•
Do not install the product in a location where a high-voltage device is installed.
•
Be sure to user the supplied insulation board to assure the noise resistance.
•
After connecting the cables, check that the correct power supply is used, that there is
no load short-circuiting or other inappropriate connections, and that the load current is
correct before turning the power ON. Faulty wiring may be the cause of failure.
•
Use a wrist strap or other similar device to avoid electrostatic charge when you touch
terminals and signal lines within a connector, and to avoid damage due to static
electricity.
•
Try to keep the length of the power cable to a minimum (less than 3 m).
3. Installation
•
When installing this code reader, use the provided insulating plate and mounting
bracket.
•
Use the provided screws for installation, and tighten to the torque specified in these
instructions.
•
Incline the bar code reader about 15° to read the target bar code.
•
Do not apply stress on the cable when mounting and using.
Precautions for Correct Use