Omron V400-R2 Series, Руководство по подключению

Страница: 16 / 71

7. Connection Procedure
13
7. Connection Procedure
This section describes the procedure for connecting the Code Reader to the Controller via
serial communications. This document explains the procedures for setting up the Controller
and the Code Reader from the factory default setting. For the initialization, refer to Section 8
Initialization Method .
7.1. Work Flow
Take the following steps to connect the Code Reader to the Controller via serial
communications.
7.2. Setting Up the Code Reader Set up the Code Reader.
↓
7.2.1. Cable Connection Connect a cable to the Code Reader.
↓
7.3. Setting Up the Controller Set up the Controller.
↓
7.3.1. Hardware Settings Set the hardware switches on the Serial
Communications Unit.
↓
7.3.2. Starting the Sysmac Studio and
Importing the Project File
Start the Sysmac Studio and import the project file.
↓
7.3.3. Checking the Parameters and
Building
Check the parameters that are set, execute the
program check on the project data and build the
Controller.
↓
7.3.4. Connecting Online and
Transferring the Project Data
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
↓
7.3.5. Transferring the Unit Settings Transfer the setting data of the Serial
Communication Unit.
↓
7.3.6. Starting the CX-Protocol and
Opening the Protocol Macro
Data
Start the CX-Protocol and open the protocol macro
data.
↓
7.3.7. Connecting Online and
Transferring the Protocol Macro
Data
Connect online with the CX-Protocol, and transfer
the protocol macro data to the Serial
Communications Unit.
↓
7.4. Checking the Serial
Communications
Execute the program and confirm that serial
communications are normally performed.
↓
7.4.1. Starting the Trace Start tracing with the CX-Protocol.
↓
7.4.2. Executing the Program Execute the program with the Sysmac Studio.
↓