![background image](http://html1.mh-extra.com/html/omron/r7d-bp/r7d-bp_user-manual_742825213.webp)
5-36
5-10 User Parameters
5
Operating Functions
Gain Parameters
Set this parameter to adjust the position loop response according to the mechanical rigidity.
The responsiveness of the servo system is determined by the position loop gain. Servo systems
with a high loop gain have a high response and can make positioning faster. To increase the
position loop gain, you must improve mechanical rigidity and increase the specific oscillation
frequency. The value should be 50 to 70 (1/s) for ordinary machine tools, 30 to 50 (1/s) for general-
use and assembly machines, and 10 to 30 (1/s) for industrial robots. Since the default position loop
gain is 40 (1/s), be sure to lower the setting for machines with low rigidity.
Increasing the position loop gain in systems with low mechanical rigidity or systems with low
specific oscillation frequencies may cause machine resonance, resulting in an overload alarm.
If the position loop gain is low, you can shorten the positioning time by using feed forward.
This parameter is automatically changed by executing realtime autotuning function. To set it
manually, set the Realtime Autotuning Mode Selection (Pn21) to 0.
Position loop gain is generally calculated as follows:
When the position loop gain is changed, the response is as shown in the following diagram.
If the speed loop gain and position loop gain are optimally set, the Servomotor operation for the
command will be delayed 2/Kp at acceleration and delayed 3/Kp at deceleration.
Pn10
Position Loop Gain
Setting range
0 to 32767
Unit
1/s
Default setting
40
Power OFF
→
ON
---
Position
Command pulse frequency (pulses/s)
Deviation counter accumulated pulses (pulses)
(1/s)
Position loop gain (Kp) =
When the position loop gain is high
When the speed loop gain is low.
Time
Servomotor
speed
Kp
3
Kp
2
Servomotor
speed
Time
Position
command
Servomotor operation
Содержание R7D-BP
